About Us    New Product Ideas    Custom Mfg.    Contact	847-455-0188
4" Square Conduit Boxes 4-11/16" Conduit Boxes Conduit Body Electrical Boxes & Covers Handy Boxes Electrical Boxes & Covers Masonry Electrical Boxes & Covers Multi-Gang Electrical Boxes & Covers Octagon & Round Electrical Boxes & Covers Stainless Steel Electrical Boxes & Covers Switch Boxes Electrical Boxes Plastic Fasteners, Hangers & Clamps Fire Alarm / Emergency Boxes & Covers Fittings, Hubs & Bushings   45° Liquid-Tight Connectors   90° Liquid-Tight Connectors Back-To-Back Connectors   Chase Nipples   Electrofrom Pipe Inserts   EMT Compression Connectors   EMT Compression Couplings   EMT Insulating Bushing   EMT Set Screw Connectors   EMT Set Srew Couplings   Floor Flanges   Male Enlargers   MC/BX Saddle Type Connectors   No-Thread Connectors   No-Thread Couplings   Off-Set Conduit Nipples   Reducing Bushings   Romex / BX Cable Clamps   Split-Collar Ground Bushing   Steel Locknuts   Straight Liquid-Tight Connectors   Threaded Rigid Couplings   Three (3) Piece Coupling   Watertight Hubs (Insulated Throat) Fixture Whips & Grips GFCI--Ground Fault Circuit Interrupters Grounding Products Lighting & Lamps & CFL Bulbs Service Entrance Products Switches, Devices & Receptacles Tools & Install Accessories Wall Plates Weatherproof Boxes & Covers Aerial Drop Wire Hardware Beam Clamps Bridle Rings Bulk Wire & Cable Cable Management Distribution Rings Fire Prevention Products J-Hooks Jacks, Face Plates & Bezels Patch Cables Rope, Twine & Pulling Tape   Fittings, Hubs & Bushings : Back-To-Back Connectors     PAGE: 1 of 1 3 Style(s) Available  1/2" Back to Back Connector: 2" Length 1/2" back to back back connector is two inches long and is made of steel with a zinc electoplate finish. Use with a locknut (included) to connect two boxes side by side or back to back. 1/2" Back to Back Connector 1/2" back to back connector is made of steel with a zinc electoplate finish. Use with a locknut (included) to connect two boxes side by side or back to back. 3/4" Back to Back Connector 3/4" back to back connector is made of steel with a zinc electoplate finish. Use with a locknut (included) to connect two boxes side by side or back to back.   PAGE: 1 of 1 3 Style(s) Available