About Us    New Product Ideas    Custom Mfg.    Contact	847-455-0188
4" Square Conduit Boxes 4-11/16" Conduit Boxes Conduit Body Electrical Boxes & Covers Handy Boxes Electrical Boxes & Covers Masonry Electrical Boxes & Covers Multi-Gang Electrical Boxes & Covers Octagon & Round Electrical Boxes & Covers Stainless Steel Electrical Boxes & Covers Switch Boxes Electrical Boxes Plastic Fasteners, Hangers & Clamps Fire Alarm / Emergency Boxes & Covers Fittings, Hubs & Bushings   45° Liquid-Tight Connectors   90° Liquid-Tight Connectors   Back-To-Back Connectors   Chase Nipples   Electrofrom Pipe Inserts   EMT Compression Connectors   EMT Compression Couplings   EMT Insulating Bushing   EMT Set Screw Connectors   EMT Set Srew Couplings   Floor Flanges   Male Enlargers   MC/BX Saddle Type Connectors   NM / BX Cable Clamps   No-Thread Connectors   No-Thread Couplings   Off-Set Conduit Nipples Reducing Bushings   Split-Collar Ground Bushing   Steel Locknuts   Straight Liquid-Tight Connectors   Threaded Rigid Couplings   Three (3) Piece Coupling   Watertight Hubs (Insulated Throat) Fixture Whips & Grips GFCI--Ground Fault Circuit Interrupters Grounding Products Lighting & Lamps & CFL Bulbs Service Entrance Products Switches, Devices & Receptacles Tools & Install Accessories Wall Plates Weatherproof Boxes & Covers Aerial Drop Wire Hardware Beam Clamps Bridle Rings Bulk Wire & Cable Cable Management Distribution Rings Fire Prevention Products J-Hooks Jacks, Face Plates & Bezels Patch Cables Rope, Twine & Pulling Tape   Fittings, Hubs & Bushings : Reducing Bushings     PAGES:  1 | 2 | 3  16 Style(s) Available  3/4" to 1/2" Reducing Bushing This reducing bushing fits into any 3/4" fitting to reduce the opening to a size of 1/2". Reducing bushing is made from steel with a zinc electro-plated finish. 1/2" to 3/8" Reducing Bushing This reducing bushing fits into any 1/2" fitting to reduce the opening to a size of 3/8". Reducing bushing is made from steel with a zinc electro-plated finish. 1" to 1/2" Reducing Bushing This reducing bushing fits into any 1" fitting to reduce the opening to a size of 1/2". Reducing bushing is made from steel with a zinc electro-plated finish. 1" to 3/4" Reducing Bushing This reducing bushing fits into any 1" fitting to reduce the opening to a size of 3/4". Reducing bushing is made from steel with a zinc electro-plated finish. 1-1/4" to 1" Reducing Bushing This reducing bushing fits into any 1-1/4" fitting to reduce the opening to a size of 1". Reducing bushing is made from steel with a zinc electro-plated finish. 1-1/4" to 1/2" Reducing Bushing This reducing bushing fits into any 1-1/4" fitting to reduce the opening to a size of 1/2". Reducing bushing is made from steel with a zinc electro-plated finish. 1-1/4" to 3/4" Reducing Bushing This reducing bushing fits into any 1-1/4" fitting to reduce the opening to a size of 3/4". Reducing bushing is made from steel with a zinc electro-plated finish.   PAGES:  1 | 2 | 3  16 Style(s) Available